CenturyLink DSL Setup on a Cisco 1720

I turned up a 7Mbps DSL connection with CenturyLink this evening. Here’s the configuration I used to get the circuit working. The ‘debug ppp authentication command’ helped a lot, too.

Note: To get the username and password I had to call CenturyLink technical support. The CenturyLink provisioned modems must have some mechanism to get the necessary information automatically.

interface ATM0
 no ip address
 no atm ilmi-keepalive
 dsl operating-mode auto
 pvc 0/32
  dialer pool-member 1
  protocol ppp dialer
 !
!
interface Dialer0
 ip address negotiated
 ip nat outside
 ip nbar protocol-discovery
 encapsulation ppp
 dialer pool 1
 ppp pap sent-username USERNAME password PASSWORD
!
int FastEthernet0
 ip nat inside
!
ip nat inside source list 111 interface Dialer0 overload
!
ip route 0.0.0.0 0.0.0.0 Dialer0
!
Tagged with:

Leave a Reply

Your email address will not be published.